vertical roller mill in the wear and tear of the ring will cause the decline in efficiency and grinding is not sufficient, etc., vertical roller mill will lead to negative impact on the production line, so to promptly resolve the situation of such wear.

Grinding ring is a very important part of the ultra-fine mill, it together with the grinding roller to complete the material grinding, if it appears wear and tear, then it will make the production, the material is not sufficient grinding, but also Resulting in the decline of production efficiency and other phenomena, so timely solution to this wear is very important, and this kind of wear is normal, one is not normal, the following to carry out a detailed analysis.

If it is normal wear and tear, what happens is that there is no problem with the quality of the vertical roller mill itself, and then the operation in production is relatively standardized, but due to the force in the production of the part, gradual wear phenomenon , For this wear, only through lubrication, to reduce the extent of wear and tear, when the wear and tear when serious, be replaced;

The operation, because the vertical roller mill for the nature of the feed, speed, mode of operation and other requirements are very strict, so before the start of the job, the training of staff is very important to understand the operation Technology, we can better use, maintenance, overhaul, in order to better reduce production due to unreasonable increase in wear and tear caused by the phenomenon;

The article mainly introduces the abrasion problem of the vertical roller mill ring, mainly introduces normal wear and abnormal wear, and only slows down the normal wear by lubrication. For abnormal wear, it is mainly the quality of the equipment As well as the operation caused by the above detailed introduction of the optional performance clearance equipment and operation of two aspects of the situation, I hope for the life of the grinding ring helpful.